Beverly Hills Electrician and Plumber

What power and plumbing work do you handle in Beverly Hills?

One licensed crew covers both trades on the same property, so an estate rewire and a repipe move on a single schedule instead of two. On the power side we rebuild services to 400 amps, set subpanels, and add dedicated circuits for pools, elevators, EV chargers, and standby generators.

Big houses pull heavy, sustained loads, so we size panels and feeders for the real draw rather than a rule of thumb. We take on full rewiring, panel upgrades, and low-voltage lighting for gardens, art walls, and long driveways.

On the water side we replace corroded galvanized supply with copper or PEX, install high-recovery and tankless heaters, and run gas for ranges, pools, and fire features. The repiping page walks through how we stage a whole-home job.

Holding both licenses keeps a job that crosses trades with one crew. Put in a tankless unit and the same team sets the water, the gas, and the 240-volt circuit in one trip, so nothing waits on a second contractor and the invoice comes as one number.

Estate systems add scope most houses never see: home theaters, wine rooms, motorized gates, and security lighting on the electrical side; pressure-boost pumps, softeners, and several tankless units on the water side. One team ties all of it together.

What do Beverly Hills estate homes need most?

Capacity comes first. Square footage, a pool, an elevator, a wine room, and heavy HVAC push a lot of these homes past a 200-amp panel toward a 400-amp service. We run a load calculation, then size the service to the actual number.

In the Flats, houses from the 1920s and 1930s often still hide cloth-insulated wire and an undersized panel behind the plaster. A rewire brings them up to current code and adds grounded, GFCI-protected circuits without tearing the house apart.

Trousdale Estates and the canyons above Sunset bring long runs. Gated drives want buried feeders and proper lighting, and pool equipment, spa heaters, and landscape systems each need a dedicated, bonded circuit so nothing trips on a warm evening.

The plumbing ages the same way. Long pipe runs and dozens of fixtures mean old galvanized lines lose pressure and clay sewer laterals crack. A whole-home repipe restores flow, and a right-sized water heater keeps every bathroom hot at once.

Pools and spas earn their own note. Every pump, heater, and light wants a bonded circuit, and the gas line to the equipment pad has to run at the right size. We set both sides, so the whole setup runs safely for years.

Do you pull permits with Beverly Hills Building and Safety?

Yes. Panel changes, rewires, repipes, water heaters, and gas lines all go through the City of Beverly Hills Building and Safety. The city runs its own department, and its plan review is stricter than most.

That matters here. Inspectors expect clean, code-perfect work, and a closed permit protects your home's record when it comes time to appraise or sell. We file the paperwork and meet the inspector on site.

The city also runs its own water utility, separate from LADWP. For a repipe or a new service line we schedule the shutoff and any meter work with the Beverly Hills water department, which keeps the job from stalling.

You can check our standing yourself. We work to California code under CSLB #942404, and the license is public at the CSLB. Licensed, permitted work is simply the honest way to build here.

Review takes time, so we book inspections early and stage the work to pass on the first visit. That sidesteps the delays that come with rushed or unpermitted installs and keeps an estate project on its calendar.

Service upgrades need coordination too. When a 400-amp service calls for a new meter or a larger drop, we line up the utility and the inspector together, aiming to have power back the same day it goes down.

Flats, Trousdale, or the canyons: where do you work?

We work every part of the city, flat or hillside: the Flats, Trousdale Estates, Beverly Hills Post Office, and the canyon streets above Sunset.

Each pocket behaves differently. The Flats hold classic homes with older wiring and galvanized supply. Trousdale's mid-century estates usually need a service upgrade to carry modern loads. BHPO and the canyons add long runs and heavy landscape and pool systems.

Our Los Angeles electrician crew and our Los Angeles plumber crew are the same people, so both trades show up wherever you sit on the map.

Access shapes the plan. Narrow canyon roads and gated drives mean we sort out parking and equipment before the truck rolls, so the crew arrives ready instead of stuck at the curb.

History shapes the pipes as much as the wiring. Many pre-war homes still carry galvanized supply and clay laterals, and both fail with age. When a wall is already open for electrical work, we check the plumbing in the same visit.

What does an electrician cost in Beverly Hills?

We price by the job and hand you the number before any work starts. A service call runs $100-$250 and comes off the repair, hourly electrical labor is $58-$115, and common repairs land between $100 and $800.

Typical Los Angeles ranges for common electrical and plumbing work

These are typical Los Angeles ranges for orientation, not a quote. Every job is priced by its own conditions, so your exact number comes from a free on-site look. Get a free estimate in minutes, or call (818) 421-5290.

A Beverly Hills electrician usually prices estate work at the upper end. A 400-amp service, long feeders, and premium fixtures cost more than a straight 200-amp swap, and we spell out that exact scope before we begin.

The plumbing follows the same rule. A whole-home repipe tracks the home's size and fixture count, so we hand you a written price instead of a guess.

Three things move an estate number the most: access, finishes, and load. A rewire behind preserved plaster takes more care than open framing, and a long feeder to a canyon pool house adds material and labor. Each one lands in the written scope.

How far is the drive, and what does travel cost?

Beverly Hills is a cross-town run from our San Fernando Valley base, and we make it every week. We are straight about the distance: there is no rented local address here, just a licensed crew that drives over.

For most jobs the travel or trip charge sits inside the written price up front. You approve the full number before we start, so the drive never turns up as a line-item surprise.

One crew is the real saving. Instead of a separate electrician and a separate plumber each driving in, one team runs both trades in a single visit, which means one mobilization rather than two.

For a genuine emergency, someone picks up at (818) 421-5290 at any hour, walks you through what to do right now, then sends a licensed tech across town.

The math favors one call. Hire a plumber and an electrician separately and you pay two trip charges and juggle two calendars; a combined visit folds that into one upfront number that usually costs less over a full project.

Estate-grade work from your Beverly Hills electrician and plumber

A+ Electric & Plumbing, a licensed electrician and plumber serving Los Angeles and the San Fernando Valley, is built for the loads Beverly Hills estates put on a house. Heavy power and full plumbing sit under one license, CSLB #942404.

Here is what that buys you: one call for both trades, one crew to pull the permits, meet the city inspector, and coordinate with the Beverly Hills water department, and one invoice that matches the estimate.

We keep the work clean and permitted because this city checks closely and your home's record follows it to sale. From an EV charger install in Trousdale to a repipe in the Flats, we build it to code the first time.

Ready to start? Call (818) 421-5290 or ask for a Free Estimate. Your electrician and plumber arrive as one licensed crew, on time, with the price already set.

Frequently asked questions