Mar Vista Electrician and Plumber

Which electrical and plumbing jobs come up in Mar Vista?

One licensed crew from A+ Electric & Plumbing covers the electrical, from panels and subpanels to new circuits, lighting, and EV chargers, and the same techs handle the plumbing. Holding both trade classifications means a single visit can knock out work that usually takes two separate contractors.

• Panel upgrades and subpanels for homes that now draw more power
• New circuits for kitchens, laundry, and home offices
• EV charger installation in garages, carports, and driveways
• ADU wiring, from the subpanel to every outlet and fixture
• Repipes, water heater swaps, and drain cleaning on the plumbing side
• Gas line work for ranges, dryers, and tankless heaters

The two trades keep meeting on westside jobs. A car charger in a Mar Vista garage usually wants a new circuit, and sometimes a heavier panel. A tankless heater needs a gas line and its own breaker together. We take on the whole thing, so it stays one crew instead of two.

You will find the rest on our electrician and plumber service lists. On the same afternoon we add a garage circuit, our plumbing side can clear a stubborn kitchen drain, all on one visit.

Caught out at an odd hour? Call (818) 421-5290 and a real person picks up, then a licensed tech rolls out. A breaker that keeps tripping, a burst pipe, or no hot water counts as urgent every time.

What do the postwar homes on the westside need most?

Most houses here went up in the 1940s and 1950s, and they were wired for a fraction of today's load. The flats and the blocks up on Mar Vista Hill share the same shortfall: too little panel capacity and old branch wiring behind the plaster.

Undersized service is the first thing we find. Plenty of these homes still sit at 100 amps, a few at 60. Load up a remodeled kitchen, a wall of appliances, and a car charger, and the breakers give out. A panel upgrade to 200 amps buys real headroom.

Old branch wiring is the second. Cloth-wrapped circuits and two-prong outlets are common at this age, and a rewiring job restores grounded, code-ready circuits, which matters most in kitchens, baths, and any room near water. A Mar Vista electrician who works these streets knows what hides behind the lath.

The water side shows its age too. Original galvanized supply lines rust from the inside and choke the pressure, and once the pipe is that far gone a repipe brings the flow back. We check the pressure regulator while we are there, since a failed one wears on every fixture.

Slab foundations add one more worry. A pinhole under the slab can run for weeks unseen. A warm spot on the floor or a jump in the water bill is worth a look at slab leak repair before it undermines the concrete.

Can you wire and plumb an ADU in Mar Vista?

Yes, and a backyard unit is where one team pays off most. A new ADU needs a licensed electrician and a licensed plumber both, and we bring the two in a single crew, so the trades stay in step instead of blaming each other.

The electrical usually opens with a subpanel. A garage conversion or a new backyard unit wants its own circuits for the kitchen, the mini-split, the water heater, and the outlets. If the main panel is already maxed, we upsize it first and feed the subpanel from there.

The plumbing runs right alongside. Our plumber sets the drain, vent, and supply lines, ties them into the main house, and hangs the water heater. Because one company plans both trades, the trench and the wall get opened once, not twice.

Permits ride on every unit, and the westside ADU wave is real here. We file the electrical and plumbing permits together so the inspections do not stall the framing. One schedule, one invoice, and no gap between the sparky and the pipe crew.

Hot water is a common ADU snag. A gas tankless unit needs the plumber for gas and water plus the electrician for the vent controls and circuit, and we size it to the new kitchen and bath so a tenant never runs cold. Our water heater installation page lays out the options.

Who pulls the LADBS permits for this work?

We do. Any job that needs one goes on a permit through the Los Angeles Department of Building and Safety, or LADBS. Panel upgrades, subpanels, rewiring, ADU work, and gas lines all qualify.

We handle the filing, book the inspection, and get the work signed off. That record follows the house and protects you at resale or refinance. You can read the requirements at LADBS.

Power and water both run through LADWP on this side of town, so any meter reset or service upgrade gets lined up with the utility as part of the job. You do not have to chase two agencies yourself.

Pulling the permit beats saving a few dollars by skipping it. Unpermitted work can fail down the line, kill a sale, or void a fire claim, so every westside job goes on the permit record and gets built to California code. You can check our standing under CSLB #942404 at CSLB before we roll out.

What will a Mar Vista electrician or plumber cost?

A service call is $100 to $250 and comes off the repair, and our electrician bills $58 to $115 an hour. The table shows typical ranges in Los Angeles, not a quote for your address.

Typical Los Angeles ranges for common electrical and plumbing work

These are typical Los Angeles ranges for orientation, not a quote. Every job is priced by its own conditions, so your exact number comes from a free on-site look. Get a free estimate in minutes, or call (818) 421-5290.

On the plumbing side a common repair runs $150 to $800, and a drain-cleaning visit usually lands in the low hundreds. A repipe or a water heater swap costs more, and we put those in writing once we have seen the site.

Age and access set the number here. A house with a full panel and brittle wiring behind the plaster takes longer, and an ADU adds its own trenching and permits. Our quote is firm before any work starts, and the invoice matches it to the dollar.

Based across town, can you really cover the westside?

Fair question. Our shop is in Sunland-Tujunga, and Mar Vista is a real trip across town. We keep no westside office, and we will not pretend we do.

Still, we work these streets every week. We know the flats, the climb up Mar Vista Hill, and the Palms-adjacent blocks wedged between the 10 and the 405. What shows up is a licensed crew with the right parts already on the truck.

The Valley base helps you more than it hurts. We run electrical and plumbing calls across the region daily, keep a deep parts inventory, and can often finish both trades in one westside visit, sparing you a second appointment.

The drive is quoted up front. For most jobs the westside trip folds into the price with no separate line, and if a job needs a special run or an odd hour, any travel fee comes out before you agree.

Why make A+ your Mar Vista electrician and plumber?

A+ Electric & Plumbing, a licensed electrician and plumber serving Los Angeles and the San Fernando Valley, puts one crew on both the wiring and the pipe here. The price gets your sign-off before we start, and a real person answers the phone at any hour, not a machine.

One license is worth the most on the jobs these homes bring. An ADU, a tankless heater, or a panel-and-repipe remodel all lean on the plumber for water and gas and the electrician for the circuits, and one crew carries the lot. That is a single schedule and a single invoice, with no trade blaming the other.

We work to California code under CSLB #942404, and a written workmanship guarantee backs every job. If a detail is off when we finish, we come back and set it straight.

Ready to line something up? Call (818) 421-5290 or request a Free Estimate, and we will get you on the westside schedule this week.

Frequently asked questions