Electrician & plumber in San Pedro
San Pedro Electrician and Plumber
A+ Electric & Plumbing is the San Pedro electrician and plumber for the hillside streets above the harbor, running both trades on one license. We swap out knob-and-tube, upsize tired panels, and repipe rusted galvanized lines from Vinegar Hill to Point Fermin. One licensed crew covers the power and the water on the same visit, at a price you approve before any work begins.
- One licensed crew for the port town's power and pipe, CSLB #942404
- Service call $100-$250, credited to the repair
- Panel upgrades, rewiring, EV chargers, drains, water heaters, gas lines
- We pull LADBS permits and work to California code
- Serving Vinegar Hill, Point Fermin, Averill Park, and the waterfront
What electrical and plumbing jobs come up most in San Pedro?
A licensed San Pedro electrician and plumber from A+ Electric & Plumbing takes on panels, rewiring, outlets, lighting, and EV chargers, while the same crew runs the plumbing. With one team holding both trade classifications, a single visit can clear a wiring problem and a leak without a second contractor.
- Panel upgrades and new circuits for homes that draw more power
- Whole home rewiring where old wiring no longer meets code
- Outlet, switch, and outdoor lighting work for hillside lots
- EV charger installation in garages and hillside carports
- Drain cleaning, repipes, and water heater work on the plumbing side
- Gas line work for ranges, dryers, and tankless heaters
Both trades show up on everyday jobs above the harbor. A tankless heater in an Averill Park bungalow needs a gas line and a dedicated circuit. A car charger up a steep Vinegar Hill driveway needs a new circuit, and often a bigger panel to run it. We take the whole job, so you book one crew instead of two.
Both trade menus sit on our electrician and plumber pages. What that buys you: a sluggish cast-iron drain cleared the same afternoon a breaker gets swapped upstairs, one crew rather than two shops.
Something break at an odd hour? Call (818) 421-5290 and a real person answers, then a licensed tech rolls south to the Harbor. A breaker that will not reset, a burst pipe, or no hot water is urgent, and we treat it that way.
What do the old port-town homes need most?
The old port-town homes above the harbor need the same three things most: a rewire, a bigger panel, and fresh water lines. San Pedro grew up around the docks, so the hillside streets are lined with early-1900s Craftsman and Victorian houses, and that old stock comes with a long punch list.
Plenty still run knob-and-tube wiring, two-prong outlets, and a panel built for a 1920s load. Knob-and-tube has no ground, and a modern kitchen can push it past what it was meant to carry. A rewiring job swaps it for grounded circuits that pass inspection.
Panels are the next weak point. A house still at 60 or 100 amps chokes when a modern kitchen, a wall AC, and a car charger all pull at once. A panel upgrade gives the home the room it needs.
The damp harbor air rolling up off the working port is rough on exposed metal. It rusts a service mast, an outdoor outlet, or the guts of a panel sooner than dry inland weather would, so we use weather-rated boxes and seal the outdoor covers so a repair actually lasts.
On the water side, the galvanized supply pipe is the classic Harbor headache. It scales up with rust and starves your pressure over the years. We pressure-test the line, flag any run ready to leak, and repipe in copper or PEX when the old pipe is past saving.
Do you pull LADBS permits down by the Harbor?
Yes. We pull permits with the Los Angeles Department of Building and Safety, LADBS, for any work that needs one. A panel swap, new circuits, a rewire, or gas work all call for one here.
We handle the paperwork, book the inspection, and see the job to sign-off. That record helps later, when you sell or refinance a home above the water. The rules sit at LADBS.
Power and water both come from LADWP in this stretch of the city, so a panel job may wait on the utility to reset the meter. We coordinate that reset as part of the schedule, so you are not chasing the utility yourself.
A permit is not the corner to cut. Work done without one can fail a later inspection, hold up a sale, or void a fire claim, so we file it every time and build to California code.
Which San Pedro neighborhoods do you cover?
We cover Vinegar Hill, Point Fermin, Averill Park, and the waterfront. Each pocket carries its own era of housing, which drives the work we see most.
- Vinegar Hill: historic Craftsman and Victorian homes that need rewiring and panel upgrades
- Point Fermin: hillside homes above the bluffs with long runs and old water lines
- Averill Park: older single family homes ready for repipes and new circuits
- The waterfront: mixed-use and commercial buildings that need panel work and drain service
Our plumbing work in these older homes runs to galvanized supply lines and cast-iron drains. We clear the drains, and when a line is past saving we repipe it. The closer a house sits to the water, the faster that pipe tends to give out.
The story rhymes from a 1912 Craftsman on Vinegar Hill to a remodel near Point Fermin: dated wiring, tired pipe, and a panel built for a smaller household. One licensed crew squares away the power and the plumbing on the same visit.
What does electrical or plumbing work cost by the port?
Coming out to a Harbor-area address runs $100 to $250, credited back to the repair, and electrician labor lands at $58 to $115 an hour. The ranges below are what we see around the city, not a bid for your street.
What common electrical and plumbing work runs across Los Angeles
| Service | Typical Los Angeles range |
|---|---|
| Service call, credited to the repair | $100-$250 |
| Electrician, hourly rate | $58-$115 |
| Common electrical repair | $100-$800 |
| Panel upgrade to 200 amps | $2,500-$5,500 |
| Common plumbing repair | $150-$800 |
These are typical Los Angeles ranges for orientation, not a quote. Every job is priced by its own conditions, so your exact number comes from a free on-site look. Get a free estimate in minutes, or call (818) 421-5290.
On the plumbing side, a common repair lands between $100 and $800, and a drain-cleaning call usually sits in the low hundreds. Larger jobs like a repipe or a water-heater swap cost more, and we quote those in writing once we have seen the site.
The price mostly follows access and age. A hillside house above Point Fermin with a long service run costs more than a flat lot near the water, and an old panel can hide extra work behind the wall. Whatever it adds up to, a San Pedro electrician from our crew puts the number in writing and holds it before any work starts.
Based up in the Valley, are you really a Harbor local?
Here is the straight answer: our shop is in Sunland-Tujunga, and San Pedro is a real trip south to the Harbor. We keep no office down here, and we are not going to pretend otherwise.
What is true is that we work the Harbor regularly. The crew knows the steep hillside streets, the early port homes, and how the LADBS counter handles this end of the city. What rolls up is a licensed team already stocked for the Harbor job, not a truck that has to leave midway for parts.
Running out of the Valley pays off for you. We take electrical and plumbing calls across Los Angeles daily, so the truck carries deep stock and can usually finish both trades in a single Harbor visit, which saves you a second appointment.
Because the drive south is a long one, any travel time goes on the quote up front, before you agree to a thing, and for many jobs we fold it into the price. The CSLB lists us under CSLB #942404, so the license is easy to confirm before you book.
Two trades, one truck for your San Pedro home
A+ Electric & Plumbing, a licensed electrician and plumber serving Los Angeles and the San Fernando Valley, puts one crew on both the power and the water at your San Pedro home. You okay the price before we start, and the phone reaches a real person at any hour.
Why does a single crew matter on an old Harbor house? A tankless heater by itself needs a plumber for the gas and water and an electrician for the 240-volt line, and an old-house remodel stacks up more overlaps like it. We send the team that owns both trades, so nobody stands in the yard pointing at the other guy.
We build every Harbor job to California code under CSLB #942404, and back it with a written workmanship guarantee. Anything not right, we come back and square it away.
Ready to lock in a date? Call (818) 421-5290 or Get a Free Estimate, and we will pick a Harbor slot that works for you.
Frequently asked questions
Do you still rewire knob-and-tube in the old Vinegar Hill houses?
Yes. Plenty of the early-1900s Craftsman and Victorian homes around Vinegar Hill are still fed by knob-and-tube. With no ground and a modern kitchen load on it, that old wiring can run hot, so we swap it for grounded circuits, pull the LADBS permit, and set up the inspection. We can phase the rewire room by room so an occupied house stays livable while the work moves through.
My house is up a steep San Pedro hillside. Does that complicate the work?
It changes the staging, not the outcome. Steep driveways and long service runs up the hill mean we plan the cable length, the parking, and how we carry gear before we arrive. Point Fermin and Vinegar Hill lots often need extra wire and a longer pull to the panel. We account for all of that in the written quote, so the climb never turns into a surprise on the bill.
Should I repipe the galvanized plumbing in my Point Fermin house?
Often, yes. Homes above Point Fermin and Averill Park were plumbed with galvanized supply pipe that scales shut with rust and drops your pressure over the decades. Our plumber checks the pipe, tests the pressure, and repipes in copper or PEX when the line is past saving. You get one written price before any wall opens, and it covers the agreed scope.
What needs a permit when I update an old Harbor home?
Most of the big items do. A panel upgrade, new circuits, a rewire, and any gas line need an LADBS permit in San Pedro, and we pull it, book the inspection, and bring the work to California code. A closed permit protects you at resale or refinance and keeps your fire insurance sound. Skipping it can cost you all of that later, so we never do.
Is there an extra charge to drive down to the Harbor?
We put any travel time on the quote before you agree, never as a surprise afterward. Our shop is in Sunland-Tujunga, so San Pedro is a real run south, and for many scheduled jobs we simply fold the drive into the price. If a call needs an off-hour trip, we name that charge in advance so the final total holds no shocks.
Can the same crew do the wiring and the plumbing in one go?
Yes, that is the whole reason to call us over two separate shops. The same licensed team holds the electrical and the plumbing classification, so a job that touches both, like a tankless heater or a remodel that moves circuits and pipe together, runs as one project. You deal with one schedule, one crew, and one invoice, with nobody to chase when something needs a tweak.
How much does a 200-amp panel upgrade run above the harbor?
A 200-amp panel upgrade generally runs $2,500 to $4,500 in the typical Los Angeles range. Where it lands depends on the panel spot, the length of the service run, and whether LADWP has to reset the meter. Old Harbor homes and an aging service mast can add hours. We hand you a written price first and the invoice matches it, so a San Pedro electrician bill holds no surprise.
More coverage
Nearby areas we serve
Get a free estimate
Tell us what's going on and a licensed tech calls you back fast, with the exact price before any work starts. Electrical and plumbing, one team.
Estimates for quoted work are free. Troubleshooting or diagnosis may carry a $100-$250 service call, credited to your repair when you approve the work.
- Exact price in writing before we start
- Licensed, bonded & insured (CSLB #942404)
- One team for electrical and plumbing
Prefer to talk? Call (818) 421-5290, answered 24/7.