Sherman Oaks Electrician and Plumber

What electrical and plumbing work do you do in Sherman Oaks?

A Sherman Oaks electrician from A+ Electric & Plumbing does the full range of home power work, and the same crew handles your plumbing. On the electrical side, we upgrade panels, rewire old circuits, add outlets, and install EV chargers. On the plumbing side, we repipe, clear drains, fix leaks, and set water heaters.

• Panel upgrades and 200-amp service for heavy AC and pool loads
• Whole-home rewiring for older valley-floor and hillside houses
• EV charger installation in garages and carports
• Repiping, drain cleaning, and slab leak repair
• Water heater and tankless installation, water and gas together
• Troubleshooting dead outlets, tripping breakers, and flickering lights

Because we hold both classifications, one call covers a job that usually needs two contractors. Our Los Angeles electricians and Los Angeles plumbers share one schedule and one invoice. No finger-pointing between trades when a water heater needs a plumber and an electrician on the same day.

Most calls here are a mix. A kitchen remodel needs new circuits and a moved sink line. A tankless heater needs a gas line and a dedicated breaker. That is why folks want one Sherman Oaks plumber and electrician, not two, so the job closes in one visit.

What do Sherman Oaks homes south of Ventura need most?

Sherman Oaks homes south of Ventura Boulevard need panel capacity and updated wiring more than anything else. The hillside streets up toward Mulholland hold older houses with long wire runs and pools, each pool with its own circuit and pump. Hot valley summers push heavy AC loads, so a 100-amp panel often runs out of room.

The area splits in two. The valley floor south of Ventura has post-war ranch homes on flat lots. The hillside homes climb toward Mulholland on winding streets. Both share the same problem: wiring built for a 1960s power load, not for today's AC, EV charger, and kitchen.

That is why a panel upgrade is one of our most common jobs in this area. When the wiring itself is brittle or cloth-wrapped, a full rewire is the honest fix. We tell you which one you actually need after we look.

The plumbing tells a similar story. Older ranch homes still run galvanized supply pipe that rusts and drops your water pressure. Hillside homes deal with long drain runs and, sometimes, slab leaks under the foundation. A plumber in Sherman Oaks sees these every week, and so do we.

Pools add their own wiring. A pool pump needs a dedicated circuit, proper bonding, and a GFCI. If your pool equipment trips or the panel feels tight, that is worth a look before summer.

Do you pull permits with LADBS here?

Yes, we pull permits through the Los Angeles Department of Building and Safety, known as LADBS. Sherman Oaks sits inside the City of Los Angeles, so panel upgrades, rewires, water heater swaps, and gas line work all go through the city, not a separate valley office.

A permit is not red tape. It means an inspector checks the work against California code, and the record follows your home when you sell. You can look up permit rules at LADBS. We handle the filing and meet the inspector, so you do not have to.

Water service runs through LADWP, the same utility that handles your power. When a job touches the meter or the main, we coordinate with LADWP so the shutoff and reconnect line up with the work.

Some jobs need a permit and some do not. A simple outlet repair does not. A panel upgrade, a rewire, a repipe, or a water heater change does. We tell you up front which permits your job needs and fold the cost into the written price.

Which neighborhoods do you cover locally?

We cover all of Sherman Oaks, from the Galleria area to the hillside streets near Mulholland. That includes the busy blocks around the Sherman Oaks Galleria, the valley floor south of Ventura Boulevard, and the winding hillside roads that climb toward Mulholland Drive.

• The Sherman Oaks Galleria area and the Ventura Boulevard corridor
• The valley floor south of Ventura, with its ranch-home streets
• The hillside streets up toward Mulholland Drive
• Nearby valley neighbors: Studio City, Encino, and Van Nuys

Each part of the area brings its own work. The condos and apartments near the Galleria need panel and sub-panel work on shared meters. The ranch homes on the valley floor keep a plumber in Sherman Oaks busy with repipes. The hillside homes need long wire runs, pool circuits, and slab leak repair.

Wherever you are in the neighborhood, the same Sherman Oaks electrician and plumber shows up. We do not sub the electrical to one company and the plumbing to another. One team, one truck, both trades.

How much does an electrician or plumber cost in Sherman Oaks?

A Sherman Oaks electrician or plumber starts with a service call of $100-$250, and we credit that fee to the repair once you approve the work. Hourly electrical labor runs $58-$115. Most common repairs land between $100 and $800, depending on the part and the access.

Typical Los Angeles ranges for common jobs

These are typical Los Angeles ranges for orientation, not a quote. Every job is priced by its own conditions, so your exact number comes from a free on-site look. Get a free estimate in minutes, or call (818) 421-5290.

A Sherman Oaks plumber charges the same way we do, by the job, not the guess. What moves the price? Access, panel location, and how much wire or pipe the job needs. A hillside home with a long run from the street costs more than a flat lot near the Galleria.

The estimate is free, and the invoice matches the quote. You approve the exact price before we open a wall or a panel. No surprises at the end.

Are you far from my neighborhood?

No, we are close. A+ Electric & Plumbing is based in Sunland-Tujunga, a quick run over the hill from your neighborhood. The 210 to the 170, or Coldwater Canyon over the pass, puts us there without a long haul.

We are honest about this: we do not keep a storefront in Sherman Oaks, and we will not fake a local address. We are a valley company that covers the whole San Fernando Valley from one base. For Sherman Oaks, there is no extra trip charge, because you are right over the hill.

What you get is a real licensed crew, not a franchise dispatcher. When you call, a live person answers any hour, and a licensed tech comes out. Same team every time.

Why hire A+ Electric & Plumbing here?

A+ Electric & Plumbing, a licensed electrician and plumber serving Los Angeles and the San Fernando Valley, gives you both trades under one license, one schedule, and one invoice. That is the difference here: you call once, and the same crew handles the power and the water.

We are licensed to California code under CSLB #942404. You can verify our license at the CSLB. Licensed, bonded, and insured, with a written workmanship guarantee: if it is not right, we come back and make it right.

The dual license pays off on the jobs that need both trades. A tankless water heater needs a plumber for the water and gas, and an electrician for the circuit. We do both in one visit, so you are not scheduling two contractors around each other.

Ready to start? Call (818) 421-5290 or Get a Free Estimate. We will look at the job, quote the exact price, and put a licensed Sherman Oaks electrician and plumber on your schedule.

Frequently asked questions