Electrician & plumber in Tarzana
Tarzana Electrician and Plumber for Hills and Flats
A Tarzana electrician from A+ Electric & Plumbing takes care of the ranch homes south of Ventura Boulevard and the estates that climb toward Mulholland. We swap out aging Zinsco and Federal Pacific panels, wire pools and spas, and repipe the original galvanized lines, with the plumbing side handled by the same licensed crew. You get one schedule and an exact price in writing.
- Zinsco and Federal Pacific panel replacements across Tarzana
- Pool, spa, and guest house circuits for hillside estates
- Repiping and water heaters for the ranch homes off Ventura
- LADBS permits filed, LADWP meter work coordinated
- One CSLB #942404 crew for the wiring and the plumbing
- Exact written quote approved before work begins
Which electrical and plumbing jobs fill our Tarzana schedule?
South of Ventura Boulevard the calls run to estate work: pool and spa circuits, subpanels for guest houses, long feeder runs, and panel replacements. North of the boulevard the flats and the horse lots of Melody Acres keep us busy with repipes, water heaters, and outdoor wiring that has to survive weather and hoses.
Both trades ride on one license here. A Tarzana electrician from our crew handles everything from a dead circuit to a 400-amp service, while the plumbing side of the same team covers gas lines, drains, and supply pipe. Our Los Angeles electricians answer the phone directly, and one call sets the whole job in motion.
- Zinsco and Federal Pacific panel replacements
- Pool, spa, and landscape lighting circuits
- EV charger circuits and load calculations
- Repiping galvanized lines in copper or PEX
- Tank and tankless water heater installs
- Gas lines for pool heaters, ranges, and fire pits
Should a Zinsco or Federal Pacific panel stay in service?
Our honest answer: plan its replacement. Tarzana grew fast through the 1960s and 70s, exactly the years when Zinsco and Federal Pacific Stab-Lok panels went into thousands of Valley homes. Both brands carry a documented record of breakers that can fail to trip under fault, which is the one job a breaker exists to do.
You do not need to panic over it. The panel may sit quietly for years, and plenty have. Insurers, though, increasingly ask about the brand at renewal, and home inspectors flag them at every sale. When you are ready, a panel upgrade to a modern 200-amp load center clears the question for good.
The swap usually takes one day. We pull the LADBS permit, coordinate the LADWP disconnect, transfer your circuits to new breakers, and label everything properly, which for many of these panels is a first.
What do the hillside estates toward Mulholland need?
Distance is the defining problem up there. A driveway that climbs 300 feet means a long feeder run, and long runs mean voltage drop unless the wire carries a heavier gauge than the flatland norm. We calculate the run before quoting, so the spa at the top of the hill actually receives its full voltage.
Pools and spas concentrate the load. Pumps, heaters, and lighting want their own circuits with proper bonding, and a gas pool heater adds a gas line sized for the BTUs. Because one crew handles the trench, the conduit, and the gas pipe, the yard opens up once instead of twice.
Slab construction on the hill side brings water problems too. A hot spot on the floor or a meter spinning with everything off points to a slab leak, and we locate the failure precisely before anyone touches the terrazzo.
Do Tarzana projects permit through the LADBS office in Van Nuys?
Yes. Tarzana belongs to the City of Los Angeles, so building permits file through LADBS, and the Valley counter over in Van Nuys processes this side of town. Panel changes, repipes, water heaters, gas lines, and pool circuits all need a permit and an inspection.
We carry that whole process. The filing, the plan corrections, the inspection booking, and the final sign-off stay on our desk, not yours. Electric metering belongs to LADWP, and on a service change we schedule the disconnect and reconnect in one arc so you are not left waiting on the utility.
Permits matter extra on estate properties. Unpermitted pool wiring or an off-record gas line surfaces during escrow every time, and fixing it under deadline pressure costs more than doing it right the first time.
What does a Tarzana electrician charge for common jobs?
Hourly work bills at $58-$115, with a $100-$250 service call that we credit once you approve the repair. Estate projects get a flat written quote instead of open-ended hours, so a long run or a tricky trench never turns into a surprise.
Typical price ranges in Los Angeles for jobs we see in Tarzana
| Job | Typical range |
|---|---|
| Service call, credited on approval | $100-$250 |
| Electrician hourly rate | $58-$115 |
| Common repair, either trade | $100-$800 |
| Zinsco or FPE panel replacement, 200 amps | $2,500-$5,500 |
| Level 2 EV charger circuit | $800-$2,000 |
| Whole-home repipe | $4,000-$15,000 |
| Water heater, tank or tankless | $1,500-$3,500 |
These are typical Los Angeles ranges for orientation, not a quote. Every job is priced by its own conditions, so your exact number comes from a free on-site look. Get a free estimate in minutes, or call (818) 421-5290.
Run length moves estate prices most. A charger circuit next to the panel sits at the low end, while the same charger 200 feet up a hillside driveway needs heavier wire, conduit, and trench time. We measure first and quote the real number.
Why run both trades with one licensed crew here?
A+ Electric & Plumbing is a licensed electrician and plumber under one CSLB contractor license, which fits the way Tarzana projects actually unfold. The pool heater needs gas and power. The tankless heater needs venting, water, and a circuit. One crew closes both halves without a scheduling standoff.
The neighborhood takes its name from Edgar Rice Burroughs' Tarzana Ranch, subdivided in the 1920s, and plenty of the housing stock dates to the growth decades that followed. Houses of that vintage reward a crew that knows both systems, because the systems fail together.
You can verify CSLB #942404 at the state license board before we ever visit. Our other coverage across the Valley sits on the service areas page, and (818) 421-5290 reaches a licensed tech at any hour.
Frequently asked questions
Is my Federal Pacific panel really a problem, or just old?
It is more than age. Federal Pacific Stab-Lok breakers carry a documented history of failing to trip during overloads, which leaves a fault cooking instead of cutting off. Many insurers now ask about the brand, and inspectors flag it at sale. We test what you have, tell you plainly where it stands, and quote a modern replacement panel if you want the number.
Can one panel carry a pool, a spa, and an EV charger?
A 200-amp service usually can, and a load calculation settles it before anyone spends money. We add up the pump, heater, charger, air conditioning, and kitchen loads the way the code book requires, then compare the total against your service size. If the panel falls short, you hear that before the charger goes in, not after.
Do you take on the long driveways up toward Mulholland?
Gladly, though they change the engineering. Every extra hundred feet of run adds voltage drop, so wire gauge, conduit size, and trench depth all get planned around the true distance. We walk the driveway with a wheel, price the actual footage, and put it in writing. The gate motor, the top-of-drive lighting, and the charger then all run at full strength.
Why does rusty water show up in my ranch house off Ventura?
Galvanized steel pipe from the 1950s and 60s sheds rust along its inner wall, and that tints the first draw of the morning brown. The same corrosion strangles your pressure. Ranch homes south of the boulevard still carry plenty of it. A copper or PEX repipe removes the problem at the source, and we quote it as one flat written number.
Does a horse property in Melody Acres need special wiring?
Outdoor circuits there work harder than most. Anything near wash racks, troughs, or irrigation wants GFCI protection, weatherproof in-use covers, and conduit buried to code depth, because water and hooves find every shortcut. We wire barns, tack rooms, and arena lighting to those standards, and the plumbing side of the crew handles the hose bibs and supply lines in the same visit.
Which offices sign off on a panel swap in Tarzana?
Two of them. LADBS issues the permit and sends the inspector, since Tarzana sits inside the City of Los Angeles, and LADWP handles the meter pull and reconnection on service work. We book both, sequence the day so your outage stays brief, and hand you the closed permit for your records when the inspector signs.
What should a Zinsco replacement cost me?
Most swaps to a modern 200-amp load center land between $2,500 and $5,500, with the permit and utility coordination included in our quote. A hillside site or a relocated panel pushes toward the top of the range. We look at your actual setup first, then commit to one written number that the invoice has to match.
More coverage
Nearby areas we serve
Get a free estimate
Tell us what's going on and a licensed tech calls you back fast, with the exact price before any work starts. Electrical and plumbing, one team.
Estimates for quoted work are free. Troubleshooting or diagnosis may carry a $100-$250 service call, credited to your repair when you approve the work.
- Exact price in writing before we start
- Licensed, bonded & insured (CSLB #942404)
- One team for electrical and plumbing
Prefer to talk? Call (818) 421-5290, answered 24/7.