Santa Monica Electrician and Plumber

What does a Santa Monica electrician and plumber take on?

One licensed crew runs both trades, so a single call covers the wiring and the water. On the power side we upgrade panels, rewire aging circuits, and add dedicated lines for heat pumps, induction ranges, and EV chargers. On the water side we track down leaks, swap corroded valves, and repipe homes the coast has worn through.

• Panel upgrades, subpanels, and heavier service for electrified homes
• Rewiring knob-and-tube or cloth wiring in older cottages
• EV charger circuits in garages and carports
• Water heater repair and tankless conversions
• Repiping pitted copper and galvanized supply lines
• Drain cleaning, slab leaks, and gas line work

See the full Los Angeles electrician and Los Angeles plumber pages for everything we cover. When a project needs both trades at once, like a tankless conversion, the same crew sets the gas, the water, and the 240-volt circuit, so the job closes in one trip instead of two.

What do Santa Monica's homes near the sand need most?

Corrosion tops the list closer to the water. The daily marine layer keeps outdoor gear damp long after inland blocks have dried, and that slow, salty moisture pits copper supply and greens up brass fittings years ahead of schedule.

The housing runs a wide range. Ocean Park holds 1920s wood cottages on original wiring and thin pipe. North of Montana leans to larger homes with heavy loads. The Pico District and Mid-City fill in with apartments and condos on shared systems.

In the older cottages we still find two-prong outlets, fabric-wrapped wire, and 60 or 100-amp panels. The city's push toward all-electric living moves them past their limit fast. A panel upgrade to 200 amps opens room for a heat pump, an EV charger, and an induction kitchen.

On the water side, old galvanized pipe and coastal damp add up to low pressure and rust-tinted water. A full repipe in PEX or copper puts an end to the pinhole leaks. A Santa Monica electrician and plumber under one roof can tackle the wiring and the pipe in the same visit.

Do you pull permits with Santa Monica Building and Safety?

Yes. Santa Monica runs its own building department, separate from the county and the City of Los Angeles, and it holds electrical and plumbing work to code. We file the permit, book the inspection, and meet the inspector on site.

Panel upgrades, rewires, repipes, water heater swaps, and gas work all need one here. You can look the department up at the City of Santa Monica, and you can confirm our license at the CSLB under CSLB #942404.

The city also runs its own water utility, so a repipe or a heater swap follows local rules on shutoffs and meters. We carry the paperwork through to the final sign-off, so the work lands on the city record and you never chase it down.

Ocean Park to North of Montana: where do you work?

We cover the whole city, from the beach flats up to the streets above Montana Avenue. Houses, condos, and small storefronts all get the same licensed crew.

• Ocean Park, where the damp air reaches the pipes first
• Sunset Park, full of postwar bungalows ready for 200-amp service
• Mid-City, a blend of apartments and single-family homes
• The Pico District, older stock on tight lots
• North of Montana, larger homes with heavier electrical loads

Wherever the address, one visit can cover both trades. That matters most in the condo and apartment pockets, where we coordinate with your HOA or building manager before we touch a shared line.

What does the work cost on the westside?

We price by the job and set the number before we start. A service call runs $100-$250 and credits to the repair, hourly electrical labor is $58-$115, and common repairs fall between $100 and $800.

Typical Los Angeles ranges for common electrical and plumbing work

These are typical Los Angeles ranges for orientation, not a quote. Every job is priced by its own conditions, so your exact number comes from a free on-site look. Get a free estimate in minutes, or call (818) 421-5290.

Santa Monica sits a westside drive from our Tujunga shop, so a small travel charge can apply. We name that figure before we schedule and fold it into the written price, so nothing new shows up at the end.

Is a westside job really local for you?

Honestly, our shop is in Sunland-Tujunga, not on the coast, and that is a real drive across the Valley and over the hill. We would rather say so on the first call than dress it up.

There is no coastal storefront with our name on it. What there is: a crew that quotes the travel time up front, writes it into the price, and holds that number. No trip fee appears later to square the distance.

Our trucks stock parts for both trades, which pays off on a longer haul. Most jobs wrap in a single visit, with a licensed tech who already knows how coastal damp treats the wiring and pipe out here.

Why choose A+ for power and water in Santa Monica?

A+ Electric & Plumbing, a licensed electrician and plumber serving Los Angeles and the San Fernando Valley, brings both trades to the coast on one license. One call covers your power and your water, on one schedule and one invoice.

That pairing pays off near the ocean. The damp wears on wiring and pipe together, so when a corroded supply line runs beside tired wiring, one crew handles both and nothing waits on a second contractor.

We build to California code and stand behind the work in writing. Our license, CSLB #942404, is public at the CSLB. When you call, a person picks up at any hour and a licensed tech follows, not an answering service.

Ready to book? Call (818) 421-5290 or ask for a Free Estimate. We quote the job and any travel time before a single task begins.

Frequently asked questions